Expert Answers about Under Seat Storage

• Where to Mount Roadmaster Invisibrake on 2021 GMC Sierra 1500
• We do not yet have any photos of the Roadmaster Invisibrake # RM-8700 mounted in a newer GMC Sierra 1500, but the beauty of this system is that it can be mounted anywhere. On the product page it mentions that the most common installation spot is under the front seat, which is where I recommend installing; you'll only need about 3" since the Invisibrake is only 2-3/4" tall. Under the back seat would be acceptable if you can find a way to fit it in the under seat storage or you can remove...
  view full answer...


• Can SMI Stay-IN-Play DUO SM99251 be Installed in Engine Compartment in 2016 Jeep Wrangler Unlimited
• There isn't a specific place that the SMI Stay-IN-Play DUO # SM99251 has to be installed on a 2016 Jeep Wrangler Unlimited. Under the seat is the easiest place to install it but if there is something in the way such as an under seat storage box then it can be installed elsewhere. If you wanted to install it in the engine compartment and there is space then you can certainly put it there. Also the # RM-88400 relay is required to prevent the towed vehicle's brake signal from overriding the...
  view full answer...


• Trailer Wiring Install on a 1998 Chevy Tracker that the Jack is Stored Under Passenger Seat
• I spoke with a customer who has performed this installation and had to remove a panel forward of the jack compartment you mentioned. He stated that prior to removing the back drivers side jack compartment panel for access to the trailer wiring plug, he had to first remove the panel in front of it, by removing a few screws. The back side panel then is very carefully pulled out a bit at a time, to separate the panel from the side. Most of the inside panels are attached by inner snaps. For...
  view full answer...


• Wiring the 118491 Harness on a 2010 Honda Pilot
• First open the rear door and fold the rear seat forward. Locate and open the storage compartment on the drivers side of the cargo area. Next, locate the grey tow plug by opening the access panel inside of the storage compartment. Then insert the converter box into the vehicles grey tow plug. Next, locate the fuse panel in the rear cargo area on the drivers side next to the rear seats that you folded down. Open fuse compartment using a trim panel remover. Then insert the relays and fuses...
  view full answer...


• Can the UWS ATV Storage Box with Handles Be Used As a Seat
• Yes, you will have no issues using the UWS ATV Storage Box with Handles part # UWS01051 as a seat. These toolboxes are built extremely well and are very durable so they will last a long time. I have attached a photo below.
  view full answer...


• Can the Bestop Instatrunk Custom Cargo Area Storage Unit # B4270201 Be Installed without Rear Seat
• Yes, the Bestop Instatrunk Custom Cargo Area Storage Unit # B4270201 can install and will function in your 2012 Jeep Wrangler regardless of if you have the rear seat installed. I attached a link to the installation instructions for you to check out as well.
  view full answer...


• Firestone Air Spring Compressor Installation Location on a 2006 Dodge Ram 1500 2wd
• We did a Firestone Ride-Rite Air Helper Springs install on a Dodge Ram pickup some time ago with a compressor and a single in cab control. We installed the compressor on top of the drivers side wheel well liner. This location is close to the vehicle battery and pretty much protected from water and road debris so the compressor will last longer and the air lines can be ran easily into the cab to the controller. When installing the compressor you can mount it just about anywhere you want...
  view full answer...


• Installation of Honda Pilot Factory Tow Package Wiring # 118253 on 2010 Honda Pilot With Tow Package
• The Honda Pilot Factory Tow Package Wiring, part # 118253, you have referenced will provide a 7-Way trailer connection at the rear of the vehicle, as long as your 2010 Honda Pilot has the Factory Tow Package. That means it is wired from the factory with the plug under the rear bumper which will accept a 7-Way trailer connector. It comes with the necessary fuses, relays, and converter box to add the 7-Way. I am including a link to the installation instructions on the # 118253 kit. The...
  view full answer...


• Do Spring Seats Have to Be Welded to Install Axle Over Under Kit
• Yes when you do an over-under kit you have to weld the seats to the axle for it to be installed properly. It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under conversion kit # K71-385-00.
  view full answer...


• What are the Bolts on the Spring Seats for on Dexter Over Under Conversion Kits
• There are nuts on the bolts attached to the spring seats in over/under conversion kit # K71-384-00. The nuts are to adjust the spring seats so that they positioned properly (parallel with original spring seat). And they also transfer road shock/brake torque from the new spring seat to the factory spring seat.
  view full answer...


• How do the WeatherTech Floor Mats WT442353 Install in a 2013 Chevy Tahoe
• The WeatherTech floor mot # WT442353 is designed to fit the floor in front of, under, and a little behind the second row of seats on a 2013 Chevy Tahoe that has 3 rows of seats with the second row bucket seats. The second row bucks seats would have to come out to install this mat since part of it fits under/behind the second row bucket seats. For the part that just fits in front of the seats and does not go under/behind I recommend # WT440662. If you could tell me the seat configuration...
  view full answer...


• Does the RoughRider Saddle Bar Block Rear Seat from Going Up or Down
• I spoke with my contact at Bestop and she stated that the 6 inch wide RoughRider saddle bag, # B5411035, will not interfere with operation of the rear seat. The same goes if you are using 2 bags, one on each side. I have included a link to the installation details for you to view.
  view full answer...


• How to Wire Superwinch LT3000
• First you want to make sure you mount the solenoid close to the battery, under the seat or frame or in the storage box. Next route the red wire from the handlebar switch to the ignition switch and connect to the wire that is powered when ignition is in the on position. Then route the two wires from the solenoid to the motor. Next route the two wires from the solenoid to the battery and attach the circuit breaker to the end of the red wire. Wrap the circuit breaker with electrical tape....
  view full answer...


• Does the Seat on Classic Accessories Pontoon Boat Swivel
• The seat on the Classic Accessories Pontoon Boat # CA69660 can be adjusted forward and backward but it does not fully swivel. This is a really nice, high-capacity pontoon boat that features 20 pockets, 2 insulated drink holders, 3 positions to mount brass oarlocks and 2 included aluminum oars that break into 2 pieces for easy storage. If you also need an air pump, you can use # 052963611113.
  view full answer...


• Will Roadmaster InvisiBrake Braking System Fit Under Passenger Seat on a 2013 Jeep Wrangler
• The ideal location for the controller box of the InvisiBrake, # RM-8700, is under the drivers or passengers seat. However, it can be mounted anywhere in the interior of the vehicle; under the rear seats, in the trunk, or behind panels. I have included a link to the instructions to the right. Based on those you should be able to determine that best mounting location for you. I have also linked a couple of installation videos for you.
  view full answer...


• Do Old Spring Seats Need To Be Removed to Install Dexter Over/Under Kit
• Yes. You don't need to cut off the old spring seat on your axle when installing the Dexter Over/Under Conversion Kit # K71-385-00; the old spring seat should not be in the way of the new U-bolts that are used to install the axle flip so you don't need to cut it off if you don't have the means.
  view full answer...


• Roadmaster Invisibrake Installation in 2020 Jeep Glaidator Overland
• Absolutely. The Roadmaster InvisiBrake Supplemental Braking System # RM-8700 typically installs under the driver's seat for easy accessibility but it is not the only place it can be mounted. You can mount it anywhere in your towed vehicle that is convenient for you as long as you can still access the adjustment knob. For example, we have installed that unit under the passenger side seat and in the rear cargo area for customers that preferred those locations. As long as you follow the...
  view full answer...


• Where Does Power Wire of Trailer Wiring for 2018 Jeep Grand Cherokee Need to Run
• The power wire of the Tekonsha trailer wiring kit part # 118727 needs to run to the battery of the vehicle so for your 2018 Jeep Grand Cherokee you'd need to run it to the battery under the seat. Check out the install video link I attached for more info.
  view full answer...


• Can Hot Lead for Tekonsha T-One Wiring Harness Be Run to Battery Under Seat on 2015 Dodge Durango
• The hot lead for the Tekonsha T-One Vehicle Wiring Harness # 118617 can indeed be run to the positive post on the battery you mentioned under the passenger seat of your 2015 Durango. This is the vehicle's main battery, as the terminals under the hood simply feed from this unit. This just gives you the option of running the hot lead to that terminal under the hood or directly to the battery in the cab. Whichever method is easiest for you is the right method! I have attached an install...
  view full answer...


• Instructions for Installing a T-One Wiring Harness # 118449 on a 2011 Toyota Higlander
• The connector you are looking for is located over on the driver side behind the storage panel in the back of your Highlander near the driver side blinker. You are going to need to remove the rear cargo floor and fold up the forward one and also the driver side cover. To get the storage box out the screws at the bottom as well as the three push fasteners on the inboard side will need to be removed. Once you have removed the storage box you should look on the back side of the exposed area...
  view full answer...